Port Trunking Window, State | Enterasys Networks FN 100 guide

Using FN100 Trunking

To display the Port Trunking window from the FN100 Chassis View:

1.Click to display the Device menu.

2.Drag down to Port Trunking..., and release. The Port Trunking window, Figure 4-1, will appear.

Figure 4-1. The Port Trunking Window

The Port Trunking Window

The Port Trunking window features the trunking table (in the upper portion of the window), which displays the following information about each interface for which trunking is enabled:

Index

Displays the port’s sftrunkIfIndex identifier.

State

Indicates the port’s trunking condition (sftrunkState). The possible states are:

•closed — trunking is enabled, and the trunking protocol is attempting to establish a trunk connection, but the port has not yet received any trunking PDUs.

•oneway — trunking is enabled, and the trunking protocol is attempting to establish a trunk connection, but incoming trunking PDUs do not indicate that

4-2	The Port Trunking Window

Image 44

Enterasys Networks FN 100 manual Port Trunking Window, State

Contents

FN 100 User’s Guide Page Virus Disclaimer Page Restricted Rights Notice Page Contents Index Chapter Using FN100 TrunkingChapter Workgroup Configuration Using the FN100 User’s Guide Introduction Related Manuals Software Conventions Common FN100 Window Fields Device NameIP Address Location Using the Mouse MAC AddressPort Number Uptime Using Window Buttons Getting Help from the Global Technical Assistance Center Using On-line HelpGetting Help Introduction Introduction Getting Help FN100 Chassis View Connection Status Viewing Chassis InformationFront Panel Information Boot Prom Port StatusFirmware Time Menu Structure Device Menu Port Status Menu Port Menus Utilities MenuHelp Menu Status FN100 Port Status DisplaysSelecting a Port Status View Errors LoadMapping Speed Port Status Color Codes Chassis Manager WindowType Viewing the Port Description Viewing Hardware TypesViewing the Device Type Using Device Find Source Address Managing the Hub Component Port Instance Viewing I/F Summary Information Index DescriptionPhysical Status Logical Status Raw Counts Rate Viewing Interface Detail Error AddressUnicast Non-Unicast Making Sense of Detail Statistics Alignment Receive ErrorsViewing Csmacd Statistics Transmission Errors Collision Errors Enabling and Disabling Ports To enable or disable a bridge port FN100 Virtual Switching Performing Virtual Switching Configuring Your Virtual Switch Settings Update Defining a Default Switch Change Default Switch Window FN100 Virtual Switching Performing Virtual Switching Using FN100 Trunking Port Trunking Window State Rmt IP Address Last ErrorRmt Bridge Id Link Ordinal Link CountLast Change Clear Enabling and Disabling Trunking Using FN100 Trunking Port Trunking Window Workgroup Configuration Configuring a Workgroup Workgroup Configuration Deleting a Workgroup Workgroup Configuration Configuring a Workgroup Index Index-2