Enterasys Networks G3G124-24, G3G124P-24 Power LEDs, IOM Status LEDs, Fixed and IOM Port LEDs

Checking the LEDs

Power LEDs

The two power LEDs, marked PWR1 and PWR2, indicate voltage for the primary and secondary power inputs. Table 3‐2 describes their status.

Table 3-2 Power LED Definitions

Display	Status
Off	Power supply not present.
Green	Normal operation.
Amber	Not enough power for redundancy. Operating in additive power mode.
Red	Power failure.

IOM Status LEDs

The three IOM status LEDs, marked POWER OFF ‐ SLOT 2, SLOT 3, and SLOT 4, indicate operational status of installed modules as described in Table 3‐3.

Table 3-3 IOM Status LED Definitions

Display	Status
Off	IOM not present.
Solid Green	Normal operation.
Blinking Green	Booting up / shutting down.
Amber	Safe to remove module. Refer to “Removing an IOM” on page 2-13for correct
	procedure.
Red	Power failure.

Fixed and IOM Port LEDs

Table 3‐4 describes the status of RJ45 and combo SFP port LEDs in the G‐Series fixed front panel and installed IOM(s).

Table 3-4 Port LED Definitions

Display	Status
Off	No link established.
Solid Green	Ethernet link established without activity. For combo SFP ports, this indicates
	power up.
Blinking Green	Ethernet link established with activity.
Solid Amber	Link established without activity and failure to provide power to powered devices.
(RJ45 only)	For RJ45 ports, this indicates power up.
Blinking Amber	Link established with activity and failure to provide power to powered devices.
(RJ45 only)

Enterasys G-Series Hardware Installation Guide 3-3