System Powerup
10/100 BASE T Ports
2
The two
DEBUG Port
The
The DEBUG port may be used for connecting a terminal to the MVME5100 to serve as the firmware console for the factory installed debugger, PPCBug. The port is configured as follows:
❏8 bits per character
❏1 stop bit per character
❏Parity disabled (no parity)
❏Baud rate = 9600 baud (default baud rate at
After
System Powerup
After you have verified that all necessary hardware preparation is done, that all connections were made correctly, and that the installation is complete, you can power up the system.
http://www.motorola.com/computer/literature |