![](/images/new-backgrounds/1110609/11060933x1.webp)
Summary of Changes
The following changes were made for the 4th revision of this manual.
Date | Doc. Rev | Changes |
|
|
|
08/2001 | V5100A/IH2 | A correction was made on page |
|
| explanation of the jumper settings for Flash Bank A |
|
| and B. Flash Bank B (0) is the factory setting. |
|
| Memory Map information was also added to |
|
| Chapter 6, Programming Information. Appendix |
|
| B, Specifications was updated, and Appendix D, |
|
| RAM500 Memory Expansion Module was added. |
|
| Other corrections were made throughout the |
|
| manual. This section titled "About this Manual" |
|
| was also added. |
|
|
|
02/2003 | V5100A/IH3 | Changes were made to pages |
|
| respectively to clarify the explanation for J16 to |
|
| state that the setting of jumpers 2 and 3 only write |
|
| protect the upper 64KB of Flash memory. |
|
| Additional corrections were made to Table |
|
| duplicate information in Rows Z and D from Table |
|
| |
|
|
|
07/2003 | V5100A/IH4 | Changes were made to this section to update model |
|
| numbers and descriptions to coincide with the |
|
| MVME5100 Datasheet. Changes were also made to |
|
| correct the address of the DS1621 from $A6 to $96. |
|
| Changes were also made to specifications for |
|
| additional power ratings and additions were made |
|
| to a new thermal rating chart. |
|
|
|
Overview of Contents
The following paragraphs briefly describe the contents of each chapter.
Chapter 1, Hardware Preparation and Installation, provides a description of the MVME5100 and its main integrated PMC and IPMC boards. The remainder of the chapter includes an explanation of the installation procedure, including preparation and jumper setting information.
xvii