1 |
Hardware Preparation and Installation
7.Gently press the two PMCspan modules together and verify that P3 is fully seated in J3.
8.Insert the four screws (Phillips type) through the holes at the corners of
Note The screws have two different head diameters. Use the screws with the smaller heads on the standoffs next to VMEbus connectors P1 and P2.
MVME5100
Before installing the MVME5100 into your VME chassis, ensure that the jumpers are configured properly. This procedure assumes that you have already installed the PMCspan(s) and any PMCs that you have selected.
Perform the following steps to install the MVME5100 in your VME chassis:
Dangerous voltages, capable of causing death, are present in this equipment. Use extreme caution when handling, testing, and adjusting.
Warning
Inserting or removing modules with power applied may result in damage to module components. Avoid touching areas of integrated circuitry, static
Caution discharge can damage these circuits
1.Attach an ESD strap to your wrist. Attach the other end of the ESD strap to an electrical ground. Note that the system chassis may not be grounded if it is unplugged. The ESD strap must be secured to your wrist and to ground throughout the procedure
2.Perform an operating system shutdown. Turn the AC or DC power off and remove the AC cord or DC power lines from the system. Remove chassis or system cover(s) as necessary for access to the VME module
Computer Group Literature Center Web Site |
