B |
Solving Startup Problems
Table B-1. Troubleshooting Problems (Continued)
Condition | Possible Problem | Possible Resolution: | |
|
|
| |
II. There is a display | A. The keyboard or | Recheck the keyboard connections and power. | |
on the terminal; | mouse may be | Verify correct configuration of RS232 interface. | |
however, keyboard | connected |
| |
and/or mouse input | incorrectly. |
| |
has no effect. |
|
| |
B. Board jumpers | Check the board jumpers per the instructions in this | ||
| |||
| may be configured | manual. | |
| incorrectly. |
| |
|
|
| |
| C. You may have | Press the HOLD or PAUSE key again. | |
| invoked flow | If this does not free up the keyboard, type in: | |
| control by pressing |
| |
| a HOLD or PAUSE |
| |
| key, or by typing: |
| |
|
|
| |
|
|
| |
III. Debug prompt | A. Debugger Flash | 1. Disconnect all power from your system. | |
may be missing | 2. Check that the proper debugger devices are installed. | ||
not appear at |
| 3. Reconnect power. | |
B. The board may | |||
powerup; the | |||
| |||
need to be reset. | 4. Restart the system using the ABT/RST switch (press and | ||
board does not | |||
| hold switch down, approximately 3 - 5 seconds). | ||
autoboot. |
| ||
| 5. If the debug prompt appears, go to step IV or step V, as | ||
|
| ||
|
| indicated. If the debug prompt does not appear, go to | |
|
| step VI. | |
|
|
| |
IV. Debug prompt | A. The initial | 1. Start the onboard calendar clock and timer. Type: | |
debugger | set mmddyyhhmm <CR> where the characters indicate | ||
appears at | environment | the month, day, year, hour, and minute. The date and | |
powerup; the | parameters may be | time will be displayed. | |
board does not | set incorrectly. |
| |
autoboot. |
| CAUTION: Performing the next step (env;d) will | |
B. There may be some | |||
| change some parameters that may affect your system’s | ||
| fault in the board | ||
| operation. | ||
| hardware. | ||
|
| ||
|
|
|
Computer Group Literature Center Web Site |