3

PPCBug Firmware

ROM Boot Direct Ending Address = FFFFFFFC?

The last location tested when PPCBug searches for a ROMboot module. (Default = 0xFFFFFFFC)

Network Auto Boot Enable [Y/N] = N?

YThe Network Auto Boot (NETboot) function is enabled.

NThe NETboot function is disabled. (Default)

Network Auto Boot at power-up only [Y/N] = N?

YNETboot is attempted at powerup reset only.

NNETboot is attempted at any reset. (Default)

Network Auto Boot Controller LUN = 00?

Refer to the PPCBug Firmware Package User's Manual, listed in Appendix C, Related Documentation for a listing of network controller modules currently supported by PPCBug. (Default = 0x00)

Network Auto Boot Device LUN = 00?

Refer to the PPCBug Firmware Package User's Manual, listed in Appendix C, Related Documentation for a listing of network controller modules currently supported by PPCBug. (Default = 0x00)

Network Auto Boot Abort Delay = 5?

The time in seconds that the NETboot sequence will delay before starting the boot. The purpose for the delay is to allow you the option of stopping the boot by use of the BREAK key. The time value is from 0-255 seconds. (Default = 5 seconds)

Network Auto Boot Configuration Parameters Offset (NVRAM) = 00001000?

The address where the network interface configuration parameters are to be saved/retained in NVRAM; these parameters are the necessary parameters to perform an unattended network boot. A typical offset might be 0x1000, but this value is application-specific. (Default = 0x00001000)

3-14

Computer Group Literature Center Web Site

Page 58
Image 58
Motorola Single Board Computer, MVME5100 manual ROM Boot Direct Ending Address = FFFFFFFC?