
Default Settings
Serial Startup Code LF Enable [Y/N]=N? |
| |
A line feed can be inserted after each code is displayed to prevent it from |
| |
3 | ||
being overwritten by the next code. This is also enabled by an ENV | ||
| ||
parameter: |
| |
The list of LED/serial codes is included in the section on MPU, Hardware, |
| |
and Firmware Initialization found in Chapter 1 of the PPCBug Firmware |
| |
Package User’s Manual, listed in Appendix C, Related Documentation. |
| |
Configuring the VMEbus Interface |
| |
ENV asks the following series of questions to set up the VMEbus interface |
| |
for the MVME5100. To perform this configuration, you should have a |
| |
working knowledge of the Universe ASIC as described in your |
| |
MVME5100 Programmer’s Reference Guide. Also, refer to the Tundra |
| |
Universe II Users Manual, as listed in Appendix C, Related |
| |
Documentation for a detailed description of VMEbus addressing. In |
| |
general, the PCI slave images describe the VME master addresses, while |
| |
the VMEbus slave describes the VME slave addresses. |
| |
VME3PCI Master Master Enable [Y/N] = Y? |
|
YSet up and enable the VMEbus Interface. (Default)
NDo not set up or enable the VMEbus Interface.
PCI Slave Image 0 Control = 00000000?
The configured value is written into the LSI0_CTL register of the Universe chip.
PCI Slave Image 0 Base Address Register = 00000000?
The configured value is written into the LSI0_BS register of the Universe chip.
PCI Slave Image 0 Bound Address Register = 00000000?
The configured value is written into the LSI0_BD register of the Universe chip.
PCI Slave Image 0 Translation Offset = 00000000?
http://www.motorola.com/computer/literature |