3 |
PPCBug Firmware
Table 3-1. Debugger Commands (Continued)
Command | Description |
|
|
TA | Terminal Attach |
|
|
TIME | Display Time and Date |
|
|
TM | Transparent Mode |
|
|
TT | Trace to Temporary Breakpoint |
|
|
VE | Verify |
|
|
VER | Revision/Version Display |
|
|
WL | Write Loop |
|
|
Although a command (PFLASH) to allow the erasing and reprogramming
!of Flash memory is available to you, keep in mind that reprogramming any
Caution portion of Flash memory will erase everything currently contained in Flash, including the PPCBug debugger, if the target address addresses the
bank in which it resides.
Diagnostics
The PPCBug hardware diagnostics are intended for testing and troubleshooting the MVME5100.
In order to use the diagnostics, you must switch to the diagnostic directory. You may switch between directories by using the SD (Switch Directories) command. You may view a list of the commands in the directory that you are currently in by using the HE (Help) command.
If you are in the debugger directory, the debugger prompt
If you are in the diagnostic directory, the diagnostic prompt
PPCBug’s diagnostic test groups are listed in Table
Computer Group Literature Center Web Site |