Epson 4003353 6.3 LUBRICATION

Stylus Color Service h#anua/
Maintenance
6.3 LUBRICATION AND ADHESIVE
The printer must be lubricated properly when the printer is disassembled for component
replacement, or if the mechanical noise exceeds a certain level. EPSON recommends only the
lubricants listed in table below for this printer, both of which have been tested extensively and
found to comply with the requirements of this printer mechanism. Figure 6-2 shows the lubrication
points.
Table 6-1. Recommended Lubricants
Type
Name
Q’ty
Part No. Availabil”~
Oil
o-5
40 cc
1010513
E
G-20 40
gm B700000001
E
Grease
G-36 40 gm B703600001
E
Adhesive
NEJI LOCK #2 (G)
1000 g B730200200
E
Note)
E= EPSON Exclusive product (Not commercially available)
Table 6-2. Lubrication and Adhesive Points
Ref. No.
Lubrication/Adhesive Point
Lubricant
(1) Extreme point of the knob (Gear)
G-36 (l-3 mg)
(2)
Cut point for knob on the right main frame
G-36 (l-3 mg)
(3)
I Extreme point of shaft securing sub frame assembly
I G-36 (l-3 mg)
II
(4)
\ Gearing point of the complex gear
G-36 (l-3 mg)
I
(5)
I Both sides of gear holder (2-points)
I G-36 (l-3 mg)
I
I
(6)
Shaft located at the center frame assembly (2-points) G-36 (l-3 mg)
(7)
Cut point for the CR motor on the base frame assembly (2-points) G-36 (l-3 mg)
(8)
I Right extreme point of the eject roller assembly
I G-36 (1-s mg)
(9)
Contact point of the pressure spring and washer
G-36 (l-3 mg)
(lo)
Right side of the front paper guide
G-20 (l-3 mg)
(11) Cut point on the platen roller shaft G-20 (l-3 mg)
(12) Oil pad on the carriage 05 (l-3 mg)
(13) On securing the screw
NEJI LOCK #2
(l-3 mg)
■ Do not apply too much lubricant, as it may cause a stain on the mechanism as well as a
malfunction of the mechanism.
Rev. A
w