Paper Handling

ProblemSolution

The printer does not feed continuous paper properly (continued).

Skip over perforation is set, but the petftiration does not fall in the center of the skip.

The top of form position shifts slightly when you print several pages.

Your application program may cancel the 5kip over perforation set by DIP switch 3-3.Check that your application program’s settings are correct.

The page length may be set incorrectly. Set DIP switch 3-2 to match your paper length. If your application program allows you to use control codes, you can set the page length using ESC C or ESC C 0.

See pages 3-17, 9-13 and 9-14

The top of form position may be too high or too low. Adjust the top of form position so that the perforation is centered within the skip area. See page 3-33.

The paper may be too heavy for the built-in tractor. When you require highly accurate paper feeding such as when you print carbon copies, use the optional pull tractor. See page 5-2.

7-16Troubleshooting