Using the Paper Memory Feature

Saving information for overlappb multi-part forms-with labels

To save paper format and thickness information for multi-part forms ‘that overlap slightly and have ‘labels on them, follow the steps below.

1.Load the overlapping multi-part forms with labels onto the front tractor. (See the section on lqqdingpaper onto the front tractor in Chapter 2.)

2.Turn off the printer.

3.Use DIP switch 3-4 to select the memory area where you want the printer to store the paper format and thickness information. Memory area 1 is selected when DIP switch 3-4is off. (This is the printer’s default setting.) To select memory area 2, turn on the switch.

4.Use DIP switch 3-2 to set the page length. The page length is 11 inches when DIP switch 3-2is off and 12 inches when the switch is on. If you plan to use forms of a different page length, use software commands to set the page length after you finish saving the form’s information.

5.Turn on DIP switches 3-5and 3-6.This tells the printer you want to save information for multi-part forms that overlap slightly and have labels on them.

Note: Whenever DIP switch 3-5is on, the skip over perforation feature is valid, regardless of DIP switch 3-3’s setting.

6.Follow steps 6 through 14 on pages 3-25through 3-29.

3-30Using the Printer