Paper handling

This section describes how to use the perforation cutter with continuous paper. Before printing with the perforation cutter installed, set the page length to match your paper using your software or the printer’s DIP switchs (as described in Chapter 4).

Note:

TEPSON recommends that the perforation between pages is folded when using the perforation cutter.

TThe last page may not be ejected completely. If this happens, gently pull it out of the printer.

TThe perforation cutter can not cut the last 11 inches of continuous paper, but you can print on it.

Cutting off a printed document

You can cut off a printed document using one of the following methods:

TIf you set the cutting method through the printer driver, the printer driver setting overrides the DIP switch’s auto cut mode setting.

You can select the following from the printer driver’s paper source settings:

Tractor Front: Do not cut

Tractor Front: Cut last page only

Tractor Front: Cut each page

Tractor Rear: Do not cut

Tractor Rear: Cut last page only

Tractor Rear: Cut each page

6-18Using Printer Options