Control Panel Buttons and Lights

Tear Off (Pitch/Font) lights**

Flash when continuous paper is in the tear-off position; otherwise, the lights indicate the selected font.

LF/FF button

●Feeds paper line by line when pressed and released.

●Ejects a single sheet or advances continuous paper to the next top-of- form position when held down.

Paper Out light

●On when no paper is loaded in the selected paper source or when paper is not loaded correctly.

●Flashes when paper has not been fully ejected or a paper jam has occurred.

Pitch (Font) button** Selects a pitch and font.

Load/Eject button

●Loads a single sheet of paper.

●Ejects a single sheet of paper if a sheet is loaded.

●Loads continuous paper from the standby position.

●Feeds continuous paper backwards to the standby position.

Pause button Stops printing temporarily, and resumes printing when pressed again. When pressed for three seconds, turns on the Micro Adjust mode*. To turn off, press again.

Pause light

● On when the printer

is paused.

*Micro Adjust mode

When you hold down the Pause button for three seconds, the printer enters the micro adjust mode. In this mode, you can press the LF/FFD and Load/EjectU buttons to adjust the top-of-form or tear-off position. See Chapter 2, “Using the Printer.”

**Font select

In the Micro Adjust mode, you can select the font to use for printing by pressing the Tear Off button. The Tear Off lights turn on, off or flash to indicate the selected font.

●

Flashes when the

 

printer is in the Micro

 

Adjust mode*.

●

Flashes when the

 

print head has

 

overheated.