
The default settings control many printer functions. While you can often set these functions through your software or printer driver, you may sometimes need to change a default setting from 2 the printer’s control panel using the Default Setting mode.
The following table lists the default settings and the options you can select in the Default Setting mode. The settings are explained in detail after the table. For instructions on changing the default settings, see “Changing default settings” on page
Settings | Options |
|
|
Page length for tractor* | Length in inches: 3, 3.5, 3.66, 4, 4.5, 5.5, |
| 6, 7, 8, 8.5, 11, 70/6, 12, 14 |
|
|
Skip over perforation | On, Off |
|
|
Auto tear off | On, Off |
|
|
Auto line feed | On, Off |
|
|
Print direction | |
|
|
Software | ESC/P2, IBM PPDS |
|
|
0 slash | 0, 0 |
|
|
High speed draft | On, Off |
|
|
I/F mode | Auto, Parallel, Serial |
|
|
Auto I/F wait time | 10 seconds, 30 seconds |
|
|
Baud rate | 19200, 9600, 4800, 2400, 1200, 600, 300 |
| BPS |
|
|
Parity | None, Even, Odd, Ignore |
|
|
Data length | 8 bit, 7 bit |
|
|
Parallel I/F bidirectional | On, Off |
mode |
|
|
|
*The options available vary depending on the country of purchase.
**These settings take effect only when IBM PPDS emulation is selected.
Using the Printer |