7.Take a stack of paper and fan it. Next, tap the side and bottom of the paper on a flat surface to even up the stack.

cCaution:

Do not use envelopes, multipart forms, carbon paper, or labels in the cut-sheet feeder.

8.Insert up to 50 sheets of paper along the left paper guide.

9.Adjust the position of the right paper guide so that it matches your paper’s width. Make sure the position of the guide allows the paper to move up and down freely.

10.Push the paper-set levers back to clamp the paper against the guide rollers.

11.Remove the paper supports from the edge guides and insert the two stacker supports packed with the cut-sheet feeder into the holes on the edge guides.

12.Attach the paper guide to the cut-sheet feeder as shown below.

View from above

Release tab

Release tab

2-36Using the Printer