3.Turn on the printer. Hold down the LF/FF button to feed paper in one page.

4.Release the sprocket lock levers of the pull tractor and adjust the sprocket units to match the width of the paper. Be sure that the sprocket units on both tractors are aligned so that the paper is not crooked.

5.Open the sprocket covers. Fit the holes of the paper over the tractor pins of the sprocket units and adjust the sprocket units as necessary. (See “Printing on Continuous Paper” on page 2-10.)Close the sprocket covers.

6.If there is slack in the paper between the push and pull tractors, push in and turn the paper-feed knob on the right side of the pull tractor to remove the slack.

7.See that the paper is not crooked or wrinkled and lock the sprocket units in place.

8.Re-install the printer cover and the paper guide.

2-38Using the Printer