Panel light

Beep

Problem

 

 

state

pattern

 

 

 

Solution

 

 

 

 

 

 

 

 

 

 

 

f Paper Out

•••

Continuous paper is not fed back to the

 

 

n Pause

 

standby position.

 

 

 

 

 

 

 

 

 

Tear off the printed document at the

 

 

 

 

perforation; then press the Load/Eject button.

 

 

 

 

The printer feeds the paper to the standby

 

 

 

 

position. Press the Pause button to turn off the

 

 

 

 

Pause light, if necessary.

 

 

 

 

 

 

 

 

•••

A single sheet of paper is not fully ejected.

 

4

 

 

 

 

 

 

Press the Load/Eject button to eject the sheet.

 

 

 

Then press the Pause button to turn off the

 

 

 

 

Pause light, if necessary.

 

 

 

 

 

 

 

 

•••

Paper is jammed in the printer.

 

 

 

 

 

 

 

 

 

Clear the paper jam as described in the

 

 

 

 

previous page.

 

 

 

 

 

 

 

f Pause

The print head is overheated.

 

 

 

 

 

 

 

 

 

Wait a few minutes; the printer resumes printing

 

 

 

 

automatically once the print head has cooled.

 

 

 

 

 

 

 

f All the lights

• • • • •

An unknown printer error has occurred.

 

 

on the control

 

 

 

 

 

Turn off the printer and leave it off for several

 

 

panel

 

 

 

 

 

minutes; then turn on the printer again. If the

 

 

 

 

error recurs, contact your dealer.

 

 

 

 

 

 

 

n= on, f = flashing

•••= short series of beeps (three beeps)

• • • • • = long series of beeps (five beeps)

Note:

The printer beeps once if you press a control panel button when the corresponding function is not available.

Troubleshooting 4-3