Epson TM-H5000/H5000P manual Adjustments and Settings

4.Remove the paper from the printer and feed another sheet of slip paper into the printer to print characters from the character table. Continue to feed slip paper into the printer until the self test prints the following:

***completed***

The printer is ready to receive data as soon as it completes the self test.

Note:

If you want to pause the self test manually, press the REVERSE button. Press the REVERSE button again to continue the self test.

Adjustments and Settings

The TM-H5000/H5000P is set up at the factory to be appropriate for almost all users. It does, however, offer some settings for users with special requirements.

It has DIP switches that allow you to change communication settings, such as handshaking and parity check, as well as print density and connection to a customer display.

The TM-H5000/H5000P also has a near-end sensor for the paper in the receipt section. This can give you a warning when the paper is almost out. If you find that there is not enough paper remaining on the roll when the near-end sensor is triggered, you can change the near-end sensor setting.

See Appendix A if you need to make any of these changes.

Setting Up the Printer 1-17