If there is no paper jam and the printer has been printing for quite a while, the print head may be overheated. If the print head is overheated, the printer will resume printing when the head has cooled (usually within two or three minutes).
If there is no paper jam and the print head is not overheated, turn off the printer and turn it back on after about 10 seconds. If the ERROR light is still flashing, contact a qualified service person.
The ERROR light is off, but nothing is printed.
Try to run the self test to check that the printer works properly. See the self test instructions in Chapter 1 to run the self test. If the self test does not work, contact your dealer or a qualified service person.
If the self test works properly, check the following:
1.Check the connection at both ends of the interface cable between the printer and the computer. Also make sure that this cable meets the specifications for both the printer and the computer.
2.The data transmission settings may be different between the printer and computer. Make sure that the printer’s DIP switch settings for data transmission are the same as the computer’s. You can print the printer’s interface settings using the self test.
If the printer still does not print, contact your dealer or a qualified service person.
The slip section of the printer sounds like it is printing, but nothing is printed.
The ribbon cassette may not be installed properly. See the instructions in Chapter 1.
The ribbon may be worn out. Replace the ribbon cassette as described in Chapter 1.
