Extron electronic DMP 64 manual View, Tools, Meter Bridge

View

•Meter Bridge — Opens a Meters dialog box with real-time meters that monitor signal levels at each input and output.

NOTE: Meter Bridge is available in Live mode only while connected using the LAN port.

Figure 16. Meter Bridge

•Re-enable all dialogs — Re-enables all dialog boxes, the pop-up windows that allow changes to block parameters.

•Error log — Lists error messages as a troubleshooting tool.

•Group Controls — Opens the Group Controls dialog box (see Group Masters on page 69).

Tools

The Tools menu contains the following items and sub-menu:

•Presets — Provides three options:

•Mark All Items — Mark (select) all parts of the current configuration (excluding presets), including processors and mix-points to save as a partial preset.

•Save Preset — Save the currently marked processors, and mix-points as a partial preset.

•Clear Marked Items — Unmark (deselect) all parts of the current configuration (excluding presets), including processors and mix-points.

•Protected Configuration — Live mode only. Allows a user (typically the installer) to save and recall a protected configuration. The protected configuration is useful to establish parameters and values (with the exception of the device

IP address) in a known state, either as a troubleshooting tool or as a baseline configuration. A protected configuration, once saved in the device, is always present and cannot be overwritten without entering a user-defined Personal Identification Number (PIN) password. The protected configuration is restored without a PIN.

NOTE: The default PIN is 0000.

•Save — Save the current configuration (excluding presets), including processors and mixes as a password protected configuration. The DSP Configurator program prompts for a PIN to save.

•Recall — Recall the protected configuration.

•Change PIN — Change the PIN associated with the protected configuration.

DMP 64 • Software Control 23