Extron electronic DMP 64 manual Filter Dialog Box, Filter Not Bypassed, Type, Frequency, Parameter

Figure 25. Filter Dialog Box, Filter Not Bypassed

Above the graph, each filter has a "handle" (circled in red above for the parametric EQ filter) placed directly above the cutoff or center frequency. The handle number corresponds to the filter number (also outlined in red). Clicking a handle or clicking the table row brings focus to that filter. <Click+hold+dragging> the handle horizontally changes the cutoff or center frequency to a new position on the x axis.

The table below shows each filter type with default parameter settings. The table immediately following shows the range for each parameter.

Type	Frequency		Parameter 1	Parameter 2
Parametric	1000.0	Hz	Boost/Cut: 0.0 dB	Q: 1.0
High Pass	100.0	Hz	Slope: 6 dB	N/A
Low Pass	10000.0	Hz	Slope: 6 dB	N/A
Bass (Tone)	100.0	Hz	Boost/Cut: 0.0 dB	Slope: 6 dB
Treble (Tone)	8000.0	Hz	Boost/Cut: 0.0 dB	Slope: 6 dB

Filter Parameter	Settings Range
Frequency	20 Hz to 20 kHz
Tone (Boost/Cut)	-24 dB to +24 dB
Q (Parametric EQ only)	0.707 to 15.000
Slope (HP & LP filters only)	1st Order (6 dB) and 2nd Order (12 dB)

DMP 64 • Software Control 34