Extron electronic DMP 64 manual Selecting Live Mode and Pushing or Pulling Data

Selecting Live Mode and Pushing or Pulling Data

To switch from Emulate mode to Live mode:

1.Select the desired connection to the DMP 64 and make the proper connections.

NOTE: Extron recommends connection with the Ethernet LAN port when using DSP Configurator.

2.Click the Mode Live button, (see figure 52, B). The Communication Type selection window appears.

2

3	3		3
	4a	5a	Extron USB device
			6a
	or	5b	or

4b

4c 5c 6b

Figure 52. Selecting Live Mode

3.Click one of the following tabs:

•TCP/IP for connection using the LAN port (preferred) — proceed to step 4,

•RS-232for connection using either of the rear panel RS-232 ports — proceed to step 5, or

•USB for connection using the front panel configuration port — proceed to step 6.

4.If TCP/IP is selected in step 3:

a.Observe the IP Address field in the IP connection window. The field displays the last IP address entered.

•If the IP address is correct, proceed to step 4b.

•If the IP address is not correct, either click in the IP Address field and enter the IP address or click the drop-down arrow to open a list and select from a recently used address. Proceed to step 4b.

NOTE: If the local system administrators have not changed the address, the factory‑specified default, 192.168.254.254, is the correct value for this field.

b.If the device is password protected, click in the Password field and enter the appropriate administrator password.

c.Click OK.

The Synchronize with Device dialog box (see figure 53 on page 79) opens.

Proceed to step 7.

DMP 64 • Software Control 77