Extron electronic MAV Plus Series manual Example 1 Creating a set of ties

Operation, cont’d

Example 1: Creating a set of ties

In the following example, input 5 video and audio are tied to outputs 3, 4, and 8. The steps show the front panel indications that result from your actions.

NThis example assumes that there are no ties in the current configuration. 1. Clear all selections: Press and release the Esc button.

Press the Esc button to clear all selections.

	C O N T R O L
ENTER	PRESET	VIEW	ESC

The button flashes once.

2.Select video and audio for the tie: If necessary, press and release the RGBHV (CrossPoint 450 Plus switchers) or Video (MAV Plus video switchers) button and the Audio button until the buttons light.

I / O

RGBHV AUDIO

Press the RGBHV or Video button to toggle on and off. The button lights green when selected.

Press the Audio button to toggle on and off. The button lights red when selected.

3. Select an input: Press and release the input 5 button.

Press and release the Input 5 button.

The button lights amber to indicate that RGBHV or video and audio outputs can be tied to this input.

1 2 3 4 5 6 7 8

17 18 19 20 21 22 23 24

I

N

4. Select the outputs: Press and release the output 3, output 4, and output 8 buttons.

Press and release the Output 3, Output 4, and Output 8 buttons.

The buttons blink amber to indicate that the selected RGBHV or video and audio input will be tied to these outputs.

1 2 3 4 5 6 7 8

171819 20 21 22 23 24

	C O N T R O L
	ENTER PRESET VIEW	ESC
O
U	The Enter button blinks
	to indicate the need to
	confirm the change.

NYou can cancel the entire set of ties at this point by pressing and releasing the Esc button. The Esc button flashes once.

3-14 CrossPoint 450 Plus and MAV Plus Switchers • Operation