Extron electronic MAV Plus Series manual Table of Contents, cont’d

Table of Contents, cont’d

Setting RGB delay .(systems with wideband BMEs)	3-27
Example 6: Setting the RGB delay .for an output	3-27
Using presets	3-29
Example 7: Saving a preset	3-30
Example 8: Recalling a preset	3-31
Muting and unmuting outputs	3-32
Example 9: Muting and unmuting an output	3-32
Viewing and adjusting the input audio level.
(systems with audio BMEs)	3-35
Example 10: Viewing and adjusting an input audio level	3-36
Viewing and adjusting the output volume.
(systems with audio BMEs)	3-38
Reading the displayed volume	3-39
Example 11: Viewing and adjusting an output volume level	3-41
Setting the front panel locks (Executive modes)	3-43
Selecting Lock mode 2 or toggling between mode 2 and mode 0	3-43
Selecting Lock mode 2 or toggling between mode 2 and mode 1	3-44
Performing a system reset from the front panel	3-44
Background illumination	3-45
Selecting the rear panel Remote port protocol and baud rate	3-46

Rear Panel Operations	3-47
Performing soft system resets (reset modes 3, 4, and 5)	3-48
Performing a hard reset (reset mode 1)	3-49
Optimizing the Audio (Systems with Audio BMEs)	3-49
Troubleshooting	3-50
General checks	3-50
Plasma display .S-video problem.
(CrossPoint 450 Plus wideband BMEs only)	3-50
Configuration Worksheets	3-50
Worksheet example 1: System equipment	3-51
Worksheet example 2: Daily .configuration	3-52
Worksheet example 3: Test configuration	3-53
Blank configuration worksheet	3-55

Chapter Four • Programmer’s Guide	4-1
Serial Ports	4-2
Rear panel Remote port	4-2
Front panel Configuration port	4-3
Ethernet (LAN\⤀ Port	4-4
Ethernet connection	4-4
Default IP addresses	4-4
Establishing a connection	4-5
Connection Timeouts	4-5
Number of connections	4-5
Using Verbose Mode	4-5
Host-to-Switcher Instructions	4-6

iiCrossPoint 450 Plus and MAV Plus Switchers • Table of Contents