Extron electronic MAV Plus Series IptX3@, X3#, IpzX3$, X3%, IpiX3, IpsX3, IpgX3, X3,X4,X3, EX4

Programmer’s Guide, cont’d

Command/response table for IP-Specific SIS commands

Command	ASCII command	Response	Additional
	(host to switcher\⤀	(switcher to host\⤀	description
IP setup commands
Set matrix name	EX3)CN}	Ipn•X3)]
Read matrix name	ECN}	X3)]
Reset matrix name to factory	E•CN}	Ipn•X3)]	Model name plus the last 3
default			pairs of the MAC address.
Set time and date	EX3@CT}	IptX3@]
Read time and date	ECT}	X3#]
Set GMT offset	EX3$CZ}	IpzX3$]	In the command, the divider
			between hours and minutes
			can be either a colon or a
			period. In the response, the
			divider is a colon.
Example:	E8.0CZ}	Ipz+08:00]
Set Daylight Saving Time	EX3%CX}	X3%]
Read Daylight Saving Time	ECX}	X3%]
Set IP address	EX3^CI}	IpiX3^]
Read IP address	ECI}	X3^]
Read hardware (MAC)	ECH}	X3&]
address
Read # of open connections	ECC}	X3*]
Set subnet mask	EX3^CS}	IpsX3^]
Read subnet mask	ECS}	X3^]
Set gateway IP address	EX3^CG}	IpgX3^]
Read gateway IP address	ECG}	X3^]
Set administrator password	EX3(CA}	Ipa•X3(]
Read administrator	ECA}	X3(]
password
Reset (clear) administrator	E•CA}	Ipa•]
password
Set user password	EX3(CU}	Ipu•X3(]
Read user password	ECU}	X3(]
Reset (clear) user password	E•CU}	Ipu•]
Set mail server, domain	EX3^,X4),X3(CM}	IpmX3^,X4),X3(]
name
Read mail server, domain	ECM}	X3^,X4),X3(]
name

NThe Set e-mail recipient (CR) command sets the recipient for e-mail notifications. To turn e-mail notifications on, you must then set the events that the switcher reports using one or more separate Set e-mail events (EM) commands (see the next page).

Set e-mail recipient	EX4!	,	X4@	CR	}	X4! X4@ ]
						Ipr ,	,
Example:	E72,Jsmith@folklore.netCR}
	EX4!CR}					Ipr72,Jsmith@folklore.net,]
Read e-mail recipient						X4@,]

4-22 CrossPoint 450 Plus and MAV Plus Switchers • Programmer’s Guide