Extron electronic MKP 2000 Local Operation, Front Panel Controls and Indications, Creating a tie

Local Operation

Front Panel Controls and Indications

The LED display shows the most recent input or output number entered on the numeric keys only. Ties created using other devices (other MKPs, a PC or control system, or the matrix switcher’s front panel) are not shown in the LED display.

1

1 2 3

4 5 6

7 8 9

BACK 0 CANCEL

INPUT OUTPUT

TAKE

MKP 2000

7

Front Panel Operations

Creating a tie

1. Press the Input button to specify that the next number entered is an input number.

•	The Input LED lights.
•	The LED display shows the last input selected from
	this MKP.
•	The last selected output is locked (unable to be
	changed; assigned as the output to which the entered
	input is tied unless a different output is assigned [see

2 3 4 6 5

Figure 3-1 — MKP 2000 controls and indicators

10, 1 through 9 buttons — These buttons allow you to enter an input or output when you create a tie.

2Back button — This button allows you to delete the least- significant (rightmost) digit of an entered input or output number.

3Cancel button — This button allows you to clear the LED display to 000, erasing any number that you have entered or any error message.

4Input button — This button allows you to specify that the next number that you enter with the numeric keys ( 1 ) is an input.

5Output button — This button allows you to specify that the next number that you enter with the numeric keys ( 1 ) is an output.

6Take button — This button confirms the potential tie that you have created with the input and output selection. This button is the equivalent of the Enter button on the matrix switcher’s front panel.

7LED display — This display shows the input or output number that was most-recently entered using the MKP’s numeric keys ( 1 ). In certain modes, it can also show the various IP addresses programmed into the MKP.

		steps 3 and 4]).
2.	Use the numeric keys to enter the desired input.
	•	The LED display shows the input that you enter.
	•	The Take LED blinks.
		If you push the Take button now, the selected input is
		tied to the locked output.
3.	Press the Output button to specify that the next number
	entered is an output number.
	•	The Output LED lights.
	•	The LED display shows the last output selected from
		this MKP.
	•	The last selected input is locked (unable to be
		changed; assigned as the output to which the entered
		input is tied unless a different input is assigned [see
		steps 1 and 2]).
4.	Use the numeric keys to enter the desired output.
	•	The LED display shows the output that you enter.
	•	The Take LED blinks.
5.	Press the Take button to confirm the change.
	•	The Take LED goes out.
	•	The LED display show the last output that was tied
		from this MKP.

3-2 MKP 2000 Remote Control Panel • Local Operation MKP 2000 Remote Control Panel • Local Operation 3-3