SIS Operation, cont’d
This message means that the switcher requires an administrator or user level password before it will perform the commands entered via this link. The switcher repeats the password message response for every entry other than a valid password until a valid password is entered.
Login Administrator
Login User
The switcher initiates the login message when a correct administrator or user password has been entered. If the user and administrator passwords are the same, the switcher defaults to administrator privileges.
MKP Error Responses
When the switcher receives an SIS command and determines that it is valid, it performs the command and sends a response to the host device. If the switcher is unable to perform the command because the command is invalid or contains invalid parameters, the switcher returns an error response to the host. The error response codes are:
E01 — Invalid input channel number (too large)
E10 — Invalid command
E12 — Invalid output number (too large)
E13 — Invalid value (out of range)
E14 — Illegal command for this configuration
E24 — Privilege violation (Ethernet, Extron software only)
E99 — Invalid or no response from target switcher
Using the Command/Response Table
The command/response table begins on page
ASCII to HEX Conversion Table
Space |
The MKP always redirects a subset of valid matrix switcher- specific SIS commands on its Ethernet port and, if configured in
It is not the purpose of this manual to define in detail the
Symbols are used throughout the tables to represent variables in the command/response fields. Command and response examples are shown throughout the MKP SIS commands table.
MKP 2000 Remote Control Panel • SIS Operation | MKP 2000 Remote Control Panel • SIS Operation |
