Extron electronic MVX VGA A manual Command/Response Table for SIS Commands, Symbol definitions

Symbols are used throughout the table to represent variables in the command/ response fields. Command and response examples are shown throughout the table.

Command/Response Table for SIS Commands

Symbol definitions

] = CR/LF (carriage return/line feed) (hex 0D 0A)

}= Carriage return (no line feed, hex 0D))

• = Space character E = Escape key (hex 1B)

X!	=	Input number	01 – 16
X@	=	Input number (for tie)	00 – 16 (00 = untied)
X#	=	Output number	01 – 16
X$	=	Numeric dB value	–18 to +24 (45 steps of gain or attenuation) (fefault = 0 dB)
X%	=	Audio gain	0	– 24 (1 dB/step)
X^	=	Audio attenuation	1	– 18 (1 dB/step)
X&	=	Volume adjustment range	0	– 64 (1 dB/step except for 0-to-1, which is 13 dB)
			(default = 64 [0dB])
			(See the table on page 4-8.)
X*	=	Mute, Lock mode, or power supply	0	= off/mode 0/not OK
			1	= on/mode 1/OK
			2	= mode 2
X(	=	Global preset #	0	- 32 (0 = current configuration)
X1) =		Video/audio mute	0	= no mute
			1	= video mute
			2	= audio mute
			3	= video and audio mute
X1! = Firmware version number to second decimal place (x.xx)
X1@ =		Verbose firmware version-description-upload date/time.
		See the Query controller firmware version (verbose) command on page 4-12.
X1# =		Name	12 characters maximum for input, output, and global preset names
			Upper- and lower-case alphanumeric characters and
			_ / and spaces are valid.

NThe following characters are invalid in the name: {space} ~ , @ = ‘ [ ] { } < > ’ “ ; : \ and ?.

X1$ =		Port number	1 (front) or 2 (rear)
X1%	=	Baud rate	9600, 19200, 38400, 115200
X1^ =		Parity	Odd, even, none, mark, space (Only the first letter is required.)
X1& =		Data bits	7, 8
X1*	=	Stop bits	1, 2
X1( =		Port type	0 = RS-232, 1 = RS-422
X2)	=	Number of inputs	12 or 16
X2! =		Number of outputs	8, 12, or 16
X2@ =		Part number	68-nnn-nn
X2# =		Voltage	Positive or negative voltage and magnitude
X2$ =		Temperature	Degrees Fahrenheit

PRELIMINARY

MVX VGA A Matrix Switchers • Programmer’s Guide 4-5