Extron electronic manual Quick Start PVS 204SA, FCC Class a Notice

Quick Start — PVS 204SA

FCC Class A Notice

Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at his own expense.

NThis unit was tested with shielded cables on the peripheral devices. Shielded cables must be used with the unit to ensure compliance.

Installation

This Quick Start section deals specifically with quick connectivity and installation of the PVS 204SA PoleVault™ switcher. At this stage, it is assumed that all of the necessary cable routing has been completed, and that projector ceiling hardware (e.g. ceiling mounts, projector poles, projector mounting kits) and output

NLabeling the cables correctly using the color code will make this step easier.

Inputs 1 and 2: RGB video and audio.

NTwo cables (A and B) are needed for each RGB input. Do not cross connect them.

devices have been installed. Also, any PVT transmitters should already be installed (but not yet connected) following the relevant supplied instruction manuals.

Step 1

Remove power from the switcher and any input, output, and control devices that are to be used in this installation.

PVT RGB D
Input #1
				RGB
	Cable from		1A	2A
A	B PVT Output A		I
			N
	Cable from		P
		POWER	U
	PVT Output B
			T
			S
			1B	2B
		12V
		3A MAX
Rear Panel		RGB Input Connectors on
		Rear Panel of PVS 204SA

PVT RGB D

Input #2

Cable from
PVT Output A A	B

Cable from

PVT Output B

Rear Panel

Step 2

Inputs 3 and 4: Composite video and audio.

Using the supplied colored labels, label both ends of all audio/video input cables. Ensure that the labels used match the input signal type that the cable will carry. See chapter 2, “Installation”, “Labeling and connecting the A/V input cables” section, for wiring diagrams and input color coding table.

NIn some installations it may be prudent to label the cables before routing them.

PVT CV D

Input #3

Rear Panel

		PVT CV D
		Input #4
	VIDEO
Cable from	3
PVT Output
	Cable from
	PVT Output
	4
Composite Video Input
	Connectors on	Rear Panel
Rear Panel of PVS 204SA

Step 3

Connect input devices via PVT transmitters to the RJ-45 inputs on the rear of the PVS switcher. See chapter 2, “Installation”, “A/V input connections” section, for details and wiring diagrams.

Step 4 (optional)	AUX/MIX IN
Connect a mono audio source
to the Aux/Mix audio input on
the rear panel to mix a line-
level audio signal with	+ Positive
the selected input’s audio.	– Negative
	Ground

NThis channel is always active.