Extron electronic PVS 305SA Stage One - Install the Screen and Projector, Adjuster Plate

Stage One — Install the Screen and Projector

Stage 1

This stage involves installing the three pieces of hardware shown below.

PCM 340 Projector Drop Ceiling Mount

1-gang and 2-gang Accessory Mounting

Points (e.g., Power Sockets)Base

Plate

Pipe

Adapter

Pipe Adapter Plate

Wing Nuts (4)

T-frame
Securing
Screws (4)	Pipe Adapter
	Set Screws (2)

Where it goes: Attaches to structural ceiling, rests on

suspended ceiling.

What it does: Holds slotted pipe, PoleVault pole mount kit (PMK 550 - see Stage 4), and projector.

Slotted Pipe

(supplied with PCM 340)

Slotted

Pipe

Where it goes: Locks into place in PCM 340 pipe adapter.

What it does: Holds pole mount kit and projector.

UPB 25 Universal Projector Bracket (shown separated into the two sections)

	Adjuster Plate		Projector Bracket	Projector Securing
	(Top Section)		(Bottom Section)	Screw
		Set Screws (2)	Adjuster Plate	Threaded
				Barrels (4)
Vertical Angle		Horizontal Angle	Locking Screws (4)
Adjustment		Adjustment Screws (4)
Screws (4)		Pivot Point Screws (4)
				Arm Adjustment
				Screws (4)
	Pivot			Security Flange
	Point
		Security Flange		(on rear)
	Screw
		(on rear)
			360° Movement

Where it goes: Adjuster Plate screws onto base of slotted pipe, and Projector Bracket attaches to projector.

What it does: Attaches projector to PCM 340. Allows projector orientation to be adjusted in three planes.

PoleVault Systems Installation • Installation — Stage 1 2-2