Extron electronic PVS 305SA Verify the image location, 2e Attach the bracket to the projector

e.Using suitable screws, mount the projector onto the projector bracket, i.e., the lower portion of the UPB 25 as shown in step 2e’s image. Align it so the security flange is at the rear. A minimum of three arms need to be attached to the projector. Adjust the arms to fit as needed. Lock down the arm adjustment screws.

TAdjust the threaded barrels at the end of each arm to level the bracket.

Security

Flange

2e Attach the bracket to the projector

f.Lift the projector up to the adjuster plate and slide it into place. Tighten down the locking and pivot screws.

2f Slide and lock the projector onto the adjuster plate

3.Verify the image location

a.Connect a power cable to the projector and turn it on.

b.Verify image size and location by loosening the

PCM 340 pipe adapter plate wing nuts, and adjust the plate (left-right) to center the image.

TRemember to include the vertical and horizontal offsets when aligning the projector. Refer to the projector manual for information.

c.When satisfied tighten down the plate wing nuts.

Projector

Center Line

Measure the horizontal offset

Lens

Center Line

THorizontal offset

PoleVault Systems Installation • Installation — Stage 1 2-4