Extron electronic VLM 1000 manual Introduction - Inventory Overview, cont’d, b. Items not included

Introduction — Inventory Overview, cont’d

NIf any items in the VoiceLift Microphone boxes are damaged or missing, contact the Extron Technical Hotline (see rear cover for contact numbers).

b. Items not included

The following items are not included. However, some or all of these items may be needed for the installation at your particular site.

•Additional length of RJ-45 cabling (CAT 5, 5e, or 6 with T568A or T568B straight-through wiring)

•Installation hardware (may vary by installation):

Electrical ceiling box, 3.5" or 4.0"

Junction box

Plaster ring

Raceway

Bolts for concrete structural ceilings where needed

Dry wall anchors and screws

Spare ceiling tiles in case of accidental damage during installation

Safety wire, lag eye bolts, and strain reliefs

Heat shrink, extension cord c. Optional items

The optional items suggested below can be added to or substituted for items in the standard VoiceLift Microphone kit.

•VLR 102 SR Secondary VoiceLift Receiver

•VLC 102 Charging Station

•VLP 102 pendant microphone (additional)

•Wall charger

•Headset microphone

•Lapel microphone

•Lanyard

•Lanyard clip

•IPL T S1 Ethernet Control Interface d. Installation tools:

•Tape measure

•Screwdriver set and Tweeker

•Hole saw, keyhole saw, or razor knife

•Appropriate drill and bit set for the mounting surface

•Stud finder

•Flashlight

•Safety goggles

•RJ-45 crimpers and connectors (plenum rated, if applicable)

•Zip ties

•Vacuum cleaner

1-6 VoiceLift Microphone Installation • Introduction — Inventory Overview