11
MR-8 Owner’s Manual
4. [PHONES] jacks (1, 2)
Two jacks (1 and 2) are provided. You can use
two pairs of stereo headphones with the MR-8.
5. [PHONES VOL] control
Adjusts the headphone output level.
6. [REVERB/DELAY TIME] control
Controls the reverb time or delay time (see page
40).
7. [EFFECT] keys
Select the effect type from among ROOM, HALL,
PLATE and DELAY (see page 39).
8. [MASTER] fader
Adjusts the stereo (L and R) buss output level
(see page 32 and 33).
9. Track faders
Each fader adjusts the appropriate track play-
back level. Each of track faders 5/6 and 7/8
controls the appropriate stereo signal (see page
19, 32, and 33).
10.[REC SELECT] keys
Used to select one or two recording tracks.
You can record onto up to two tracks simulta-
neously. Pressing a key arms or unarm the cor-
responding track(s). Tracks 5/6 or 7/8 are armed
or unarmed simultaneously (see page 29, 31, and
33).
11.[PAN] controls
Control panning for tracks 1 through 4 (see page
45).
12.[EFFECT SEND] controls
Control the amount of signals from tracks 1
through 4 sent to the internal effect (reverb/de-
lay). (see page 40).
13.Internal microphone
You can make recording using the internal mi-
crophone by setting the [INPUT A SELECT] switch
on the rear panel to "INT MIC" (seepage 29).
14.Insert effect select keys
Used to select the insert effect (mic simulation
or amp simulation) for the signal from the [IN-
PUT A] jack.
When setting the [INPUT A SELECT] switch on
the rear panel to "MIC/LINE", you can use the
mic simulation effect. When setting the switch to
"GUITAR", you can use the amp simulation ef-
fect (see page 30 and 38).
15.[DISTORTION] control
Controls the amount of the distortion effect for a
guitar connected to the phone jack on the [IN-
PUT A] section.
This control is effective only when the [INPUT A
SELECT] switch is set to "GUITAR" (see page 30).
16.[TRIM] controls
Control the input gain of the [INPUT A] and [IN-
PUT B] sections (see page 30).