Fostex MR-8CD owner manual Pre-roll/post-roll time setting, 126

MR-8HD/CDOwner’s Manual (Other functions)

Pre-roll/post-roll time setting

As described earlier on page 47, when both the auto punch in/out and loop modes are active, the pre-roll and post-roll are effective in the loop function.

You can set the pre-roll and post-roll time value by the following procedure.

When both the auto punch in/out and loop modes are active, the loop starts from "the LOCATE A point minus the pre-roll time" and ends by "the LOCATE B point plus the post-roll time". The pre-roll time is initially set to four seconds, while the post-roll time is set to one second.

In other words, with the default pre-roll and post-roll time settings, when executing auto punch in/out, the MR-8HD/CD starts playback four seconds before the punch-in point, and ends playback one second after the punch-out point.

LOCATE A	LOCATE B
Point	Point

		4 sec.	1 sec.
LOOP START			LOOP END
	point		point

1)While the recorder is stopped, press the [MENU/ENTER] knob to enter the menu mode.

The display now shows the first page of the menu selection screen, where " Back" is highlighted initially (selecting " Back" returns to the previous screen).

2)Rotate the [MENU/ENTER] knob to select "System ", and press the [MENU/ENTER] knob.

The display now shows the first page of the system menu screen, where " Back" is highlighted.

You can select between "0.1s" and "10s" in 0.1 second steps.

Flashing

4)Rotate the [MENU/ENTER] knob to select the pre-roll hold time, and press the [MENU/ENTER] knob.

3)Rotate the [MENU/ENTER] knob to select "Pre Roll Time=*.*s" and press the [MENU/ENTER] knob.

The currently selected pre-roll time (by default, "4.0s") flashes. You can now set the desired pre-roll time.

The pre-roll time setting is confirmed and the display returns to the previous screen. To set the post-roll time, follow the procedure below.

5)Rotate the [MENU/ENTER] knob to select "Post Roll Time" and press the [MENU/ENTER] knob.

The currently selected post-roll time (by default, "1.0s") flashes. You can now set the desired post-roll time.

You can select between "0.1s" and "10s" in 0.1 second steps.

6)Rotate the [MENU/ENTER] knob to select the post-roll hold time, and press the [MENU/ENTER] knob.

The post-roll time setting is confirmed and the display returns to the previous screen.

7)Press the [STOP] key to exit the menu mode.

126