Fostex MR-8CD Rear panel, AC in connector Foot SW jack TRS phone jack, Input a Select switch

MR-8HD/CDOwner’s Manual (Names and functions)

Rear panel

1 2

				INPUT A SEL
				GTR CLEAN	MIC/LINE
				GTR DIST
AC-IN	USB	USB HOST	MIDI OUT	DIGITAL	FOOT SW
				OUT

7 6 5 4 3

1.	[AC IN] connector	3.	[FOOT SW] jack (TRS phone jack)
	Connect the supplied power cord to this con-		Used to connect with an unlatched-type
	nector (see page 28).		footswitch (see page 53).

2.[INPUT A SELECT] switch

This switch must be set appropriately accord- ing to the input source of the [INPUT A] chan- nel (see page 33).

	Either of the [BAL] XLR and
	[UNBAL/GUITAR] phone connec-
MIC/LINE	tors can be used. Set the switch to
	this position when the source is an
	external microphone or line level
	source.
	Either of the [BAL] XLR and
	[UNBAL/GUITAR] phone connec-
	tors can be used. You can adjust
GTR DIST	the input level and distortion using
	the [TRIM] and [DISTORTION]
	controls respectively. You can also
	use the amp simulation insert ef-
	fect.
	Either of the [BAL] XLR and
	[UNBAL/GUITAR] phone connec-
GTR CLEAN	tors can be used. You can adjust
	the input level using the [TRIM]
	control. You can also use the amp
	simulation insert effect.

unlatched-type footswitch

4.[DIGITAL OUT] connector

(Toslink optical connector)

Used to connect with an external digital de- vice using an optical cable (see page 42).

<Note>: The dust protec-

tion cap is inserted to the [DIGITAL OUT] con- nector when the unit is shipped.

Remove the cap when you use this connec- tor. If you do not use this connector, attach the dust protection cap.

If you need to connect the unit to a digital device which only provides a coaxial type digital connector (typically, an RCA pin jack), use the Fostex COP-1/96k coaxial-

optical converter (shown right).

Model COP-1/96k

Use an optical digital cable with Toslink plugs on both ends.

22