Fostex MR-8CD Starting recording, Playing back the recorded track, Undoing recording undo/redo

MR-8HD/CDOwner’s Manual (Basic operations)

<Note>: The fader for track 1 is used to ad- just the monitor level. To adjust the record- ing level, use the [TRIM] control of the [IN- PUT A] channel.

Starting recording

7)While holding down the [RECORD] key, press the [PLAY] key to start recording.

The guitar is recorded.

5)Press the [RECORD] key once (the key indicator starts flashing).

Track 1 (which is record armed) now enters

the input monitor mode and "" is shown on the home screen.

8)When recording completes, press the [STOP] key to stop the recorder.

<Note>: We recommend to press the [REC SELECT] key for track 1 to unarm track 1.

6)While playing the guitar, adjust the recording level using the [TRIM] control of the [INPUT A] channel.

Adjust the level appropriately so that the PEAK indicator does not light.

Turning the [PHONES VOL] control clockwise raises the headphone monitor level.

The screen shows the input level of track 1, as well as the stereo L and R output levels.

<Note>: Adjust the [TRIM] control properly so that the PEAK indicator does not light at the loudest part of the guitar sound. If the input level is too high, the PEAK indicator lights and the sound may be distorted or noisy.

<Tip>: When receiving a line level signal, set the [TRIM] control to left ("LINE") to get the appropriate level. When receiving a micro- phone signal, set the [TRIM] control to right ("MIC") to get the appropriate level.

Playing back the recorded track

9)Press the [REWIND] key while holding down the [STOP] key to locate the recorder to the beginning of the song.

10)Press the [PLAY] key to start playback.

You can adjust the monitor level using the track 1 fader, as well as the [MASTER] fader and [PHONES VOL] control.

If you are not satisfied with the result, use the undo/redo function to cancel the re- cording and try again.

Undoing recording (undo/redo)

If you press the [UNDO/REDO] key after finishing recording, you can return to the condition before the recording started (UNDO operation). Therefore, you can try recording again.

If you press the [UNDO/REDO] key again (after UNDO), the undo operation is canceled and you can return to the condition when the recording finished (REDO operation).

BOUNCE

MENU / ENTER

MASTERING

LOCATE

B / OUT STORE UNDO/REDO

[UNDO/REDO] key

YZ9 +-_0 DELETE

PLAY	REWIND	F FWD
END
ZERO

<Notes>: The undo/redo function is available for all kind of recordings, however, if you carry out any of the following operations after making re- cording, you cannot undo the recording.

•Carrying out new recording.

•Carrying out track or part editing.

•Turning off the power.

•Selecting another song or editing the song name.

36