Problem Solving |
| 72 |
|
|
|
E Indicates the projection lamp status.
Refer to the following table to see what the indicators mean and how to remedy problems that they indicate.
If all indicators are off, check that the power cable is connected correctly and that the power is being supplied normally. Sometimes, when the power cable is unplugged, the t indicator remains lit for a short period, but this is not a fault.
t Indicator is lit or flashing red
: Lit |
|
|
|
| : Flashing: |
| : Off |
|
|
|
Status
Cause |
| Remedy or Status |
|
|
|
Internal Error |
| Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest |
|
| address provided in the Support and Service Guide. s Epson Projector Contact List |
|
|
|
Fan Error |
| Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest |
Sensor Error |
| address provided in the Support and Service Guide.s Epson Projector Contact List |
Cool System Error |
|
|
|
|
|
High Temp Error |
| The lamp turns off automatically and projection stops. Wait for about five minutes. After about five minutes the projector |
(overheating) |
| switches to standby mode, so check the following two points. |
|
| • Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall. |
|
| • If the air filter is clogged, clean or replace it. s p.85, p.92 |
|
| If the error continues after checking the points above, stop using the projector, disconnect the power cable from the |
|
| electrical outlet, and contact your local dealer or the nearest address provided in the Support and Service Guide. |
|
| s Epson Projector Contact List |
|
|
|
|
| When using at an altitude of 1500 m or more, set High Altitude Mode to On. s p.49 |
|
|
|
|
| Set Direction to Pointing Down or Pointing Up when the projector is installed to project downward or upward. s p.49 |
|
|
|
Lamp Error |
| Check the following two points. |
Lamp Failure |
| • Take out the both lamps and check if they are cracked. s p.89 |
|
| • Clean the air filter. s p.85 |
|
|
|
|
| If it is not cracked: |
|
| If the error continues: Replace the lamp with a new lamp and turn on the power. |
|
| If the error continues: Stop using the projector, disconnect the power cable from the electrical outlet, and contact your |
|
| local dealer or the nearest address provided in the Support and Service Guide. s Epson Projector Contact List |
|
|
|
