Problem Solving

 

81

 

 

 

Other problems

The Remote Control does not work

Check

Is the remote control light-emitting area pointing towards the remote receiver on the projector when it is operated?

Is the remote control too far from the projector?

Is direct sunlight or strong light from fluorescent lamps shining onto the Remote Receiver?

Is the correct setting for the remote receiver selected?

Are the batteries dead or have the batteries been inserted correctly?

Are the remote control ID and the projector ID matched?

Does Remote Control Type match the remote control that you are using?

Is the optional remote control cable connected to the remote control or to the projector's remote port?

Remedy

Point the remote control towards the Remote Receiver.

Operating range s Quick Start Guide

The operating range for the remote control is about 15 m. s Quick Start Guide

Set the projector up in a location where strong light does not shine onto the remote receiver. Or set the remote receiver to Off from Remote Receiver in the configuration menu. s Settings Menu - Remote Receiver p.48

Check the Remote Receiver from the configuration menu. s Settings Menu - Remote Receiver p.48

Make sure the batteries are inserted correctly or replace the batteries with new ones if necessary. s p.88

Make sure the ID for the projector you want to operate and the ID for the remote control match. To operate all projectors by remote control regardless of the ID setting, set the ID switch on the side of the remote control to Off.

sp.32

Check the Remote Control Type on the configuration menu. s Extended Menu - Operation - Remote Control Type p.49

When the remote control cable is connected, the remote control light-emitting area or the projector's remote receiver are disabled. When not using the remote control cable set, disconnect it from the remote control and the remote port.

Nothing appears on the external monitor

Check

Are images input from a port other than the Computer or BNC input port?

Remedy

The only images that can be displayed on an external monitor are computer images from the Computer or BNC input ports. s p.106

I want to change the language for messages and menus

Check

Change the Language setting.

Remedy

Adjust the Language setting from the configuration menu. s Extended Menu - Language p.49

Page 81
Image 81
Epson EB-Z8050W, EB-Z8000WU manual Other problems, Operating range s Quick Start Guide