Problem Solving

 

78

 

 

 

Check

Has condensation formed on the lens?

Interference or distortion appear in images

Remedy

If the projector is suddenly taken from a cold environment to a warm environment, or if sudden ambient temperature changes occur, condensation may form on the surface of the lens, and this may cause the images to appear fuzzy. Set the projector up in the room about one hour before it is used. If condensation forms on the lens, turn the projector off and wait for the condensation to disappear.

Check

Is the image signal format setting correct?

Only when projecting images from a video source

Are the cables connected correctly?

Is an extension cable being used?

Is the correct resolution selected?

Only when projecting computer images

Are the "Sync.g" and "Trackingg" settings adjusted correctly?

Only when projecting computer images

Remedy

Change the setting according to the signal for the connected equipment. s Signal Menu - Video Signal p.46

Check that all the cables required for projection are securely connected. s Quick Start Guide

If an extension cable is used, electrical interference may affect the signals. Use the cables supplied with the projector to check if the cables you are using may be causing the problem.

Set the computer so that the signals being output are compatible with the projector. s "Supported Monitor Displays" p.114 s Computer documentation

Press the [Auto] button on the Remote Control or the [Enter] button on the Control panel to perform automatic adjustment. If the images are not adjusted correctly after using automatic adjustment, you can make the adjustments using Sync. and Tracking from the configuration menu. s Signal Menu - Tracking, Sync. p.46

The image is truncated (large) or small, or the aspect is not suitable

Check

Is the aspect adjusted correctly?

Is a wide panel computer image being projected?

Only when projecting computer images

Is the image still being enlarged by E-Zoom?

Is Position adjusted correctly?

Remedy

Press the [Aspect] button on the Remote Control to select an aspect suitable for the input source. s p.25

Change the setting according to the signal for the connected equipment. s Signal Menu - Resolution p.46

Press the [ESC] button on the Remote Control to cancel E-Zoom. s p.31

Press the [Auto] button on the Remote Control or the [Enter] button on the Control panel to perform automatic adjustment when the computer image is projected. If the images are not adjusted correctly after using automatic adjustment, you can make the adjustments using Position from the configuration menu.

Apart from computer image signals, you can adjust other signals while projecting by adjusting Position from the configuration menu. s Signal Menu - Position p.46

Page 78
Image 78
Epson EB-Z8000WU, EB-Z8050W manual Interference or distortion appear in images