List of Functions

 

52

 

 

 

Sub Menu

Wired LAN

PJLink Password

Web Control Password

SNMP

Function

You can make network settings.

DHCP: You can set whether or not (On/Off) to use DHCP. If this is set to On you cannot set any more addresses.

IP Address: You can input the IP address assigned to the projector.*

You can enter a number from 0 to 255 in each field of the address. However, the following IP Addresses cannot be used. 0.0.0.0, 0.x.x.x, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)

Subnet Mask: You can input the subnet mask for the projector.*

You can enter a number from 0 to 255 in each field of the address. However, the following Subnet Masks cannot be used. 0.0.0.0, 255.255.255.255

Gateway Address: You can input the IP address for the gateway for the projector.*

You can enter a number from 0 to 255 in each field of the address. However, the following Gateway Addresses cannot be used. 0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)

MAC Address: You can display the MAC address for the projector.

Set a Password to use when you access the projector using compatible PJLink software.* s p.113 You can enter up to 32 single-byte alphanumeric characters.

Set a password to use when making settings and controlling the projector using Web Control.* You can enter up to 8 single-byte alphanumeric characters.

Web control is a computer function that allows you to set up and control the projector by using a web browser on the computer running EasyMP Monitor. s EasyMP Monitor Operation Guide

You can make SNMPg settings.

Trap IP Address 1/Trap IP Address 2: You can register up to two addresses as the SNMP trap notification destination.*

To use SNMP to monitor the projector, you need to install the SNMP manager program on your computer. SNMP should be managed by a network expert.

Page 52
Image 52
Epson EB-Z8000WU, EB-Z8050W manual Sub Menu Wired LAN PJLink Password Web Control Password, Snmp