Epson EB-Z8050W, EB-Z8000WU manual List of Functions

List of Functions 53

Sub Menu

Mail

AMX Device Discovery

Projector Name

Reset

Function

When this is set, you receive an e-mail notification if a problem or warning occurs in the projector. For information on the contents of the sent email, s "Reading Problem Mail Notification Function" p.110

Mail Notification: You can set whether or not (On/Off) to be notified by e-mail. If this is set to Off you cannot set any more addresses.

SMTP Server: You can input the IP address for the SMTP server for the projector.*

You can enter a number from 0 to 255 in each field of the address. However, the following IP Addresses cannot be used. 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)

Port Number: You can display the SMTP server's port number.

The default value is 25. When editing settings from Web Control, you can change Port Number by entering a valid number from 1 to 65535.

Address 1 Setting/Address 2 Setting/Address 3 Setting: You can enter the e-mail address* and the contents of the message to receive notification when a problem or warning occurs. You can register up to three destinations. You can enter up to 64 single-byte alphanumeric characters for the e-mail addresses.

When the projector is connected to a network, set this to On to allow the projector to be detected by AMX Device Discoveryg. Set this to Off if the projector is not connected to an environment controlled with a controller from AMX or AMX Device Discovery.

Displays the projector name used to identify the projector when connected to a network.

You can reset all adjustment values for the Network menu to their default settings.

To return all menu items to their default settings, see s p.68

*When inputting numbers and passwords, the following software keyboards are displayed. Tilt the [h] button on the remote control to move the cursor to the target key, and then press the [Enter] button. Enter figures by holding down the [Num] button on the Remote Control, and pressing the numeric buttons. After inputting, press [Finish] on the keyboard to confirm your input. Press [Cancel] on the keyboard to cancel your input.

Each time the [CAPS] key is selected, it sets and changes between upper case and lower case letters. Each time the [SYM1/2] key is selected, it sets and changes the symbol keys for the section enclosed by the frame.