Fujitsu 2000 3.3.1Connecting the MMB console PC, Value, VT100, Parity, Data bit, Stop bit, Emulation, Bit/ second, Setting item, Flow control

CHAPTER 3 Work before Operating System Installation 3.3 Connection and Setting of MMB

3.3.1Connecting the MMB console PC

This section describes the connection of the MMB and MMB console PC.

To reconfigure the environment of the operation, connect the COM port of the MMB console PC and the External interface RS232C (COM port) of the MMB with RS232C cross cable.

For the mounting location and external interface overview of the MMB, refer to the figure below.

FIGURE 3.1 External Views of Mounting Locations and External interface of MMBTABLE 3.2 External interface of MMB

External interface	Quantity	Remark
RS232C(COM Port)	1	Used by the field engineer when setting-up the device. It does not use in
		normal operations.
LAN 1000Base- T	2	User port
LAN 100Base-TX	2	Maintenance
		-[LOCAL] : CE Port
		-[REMOTE]: REMCS Port

Set the terminal software by using following contents, at the time of connecting COM port,

TABLE 3.3 contents of setting of terminal software

Setting item	Value
Bit/ second	19200
Data bit	8
Parity	No
Stop bit	1
Flow control	No
Emulation	VT100

11