CHAPTER 4 Installation of Operating System and bundled software 4.2 Procedure to install Windows in SAN/iSCSI storage device

ROM”.

-For the UEFI Install:

-Set [Device Manager]-[PCI Subsystem Configuration]-[PCI ROM Priority] of BIOS menu to ”Legacy ROM”.

-Set [Device Manager]-[PCI Subsystem Configuration]-[OpROM Scan Configuration] of BIOS menu to “Enable” only for booting Device.

3.BIOS is set to recognize LUN of FC card.

For the settings of FC card, Converged Network Adapter and NIC for iSCSI Boot, see PRIMEQUEST 1000/2000 Series SAN Boot Environment Configuration Manual (C122-E155) .

4.The partition settings in MMB are confirmed after the internal HDD/SDD of PRIMEQUEST is removed.

-SB/IOU configuration is set

See “3.4.1 Setting the partition configuration” - Console redirection is set

See “3.4.6 Settings of Console Redirection”

-Video redirection: Enable

-Virtual media: Enable

-Various modes are set

See “3.4.5 Various mode settings”

5.Only LUN which becomes the installation target of SAN storage device is connected to the partition of

PRIMEQUEST.

For the settings of SAN storage device, see “Attached manual in the SAN storage device”.

6.I/O space is allocated in FC card of the boot path target and SAS RAID controller, RAID card. For the allocation of I/O space, see “5.5.1 How to use sadump (Linux)” and “3.4.5 Various mode settings” of PRIMEQUEST 2000 series Administration Tool Reference (C122-E177EN).

4.2.2Preparation for installation

The following preparations are done.

1.The following disk images should be prepared. Media of Windows operating system

2.FC cable is made a single path (Connection of only 1 FC cable).

4.2.3Installation of operating system

Operating system installation by SVIM is explained.

There are the following types in the operating system installation by SVIM. For the detailed procedure of the respective modes, see ServerView Suite ServerView Installation Manager.

TABLE 4.1 Operating system installation by SVIM

Mode

Function Overview

Objective

Quick

The operating system can be installed in the state recommended by

This mode is used when

Mode

Fujitsu by only executing the required minimum settings.

operating system is easily

 

 

installed.

Guide

It is set according to wizard set up information. The information that was

This mode is used for

Mode

set, is saved in a configuration file and can be used at the time of re-

advanced setting of RAID and

 

install

operating system.

All the inserted windows are examples of display and the contents displayed by the system configuration, etc. are different.

Operations

1.Make the settings by which the ServerView Suite DVD is booted from the virtual media for the partition.

For settings, see“1.6.2 Remote control operation (BMC)” of PRIMEQUEST 2000 series Administration Manual (C122-E175EN).

48