Task | Alert message | Page |
Installation | High temperature |
|
| To prevent injury, never touch the HDD while it is hot. The DE and LSI | 93 |
| become hot during operation and remain hot immediately after turning off the |
|
| power. |
|
Diagnostics and | Data loss |
|
Maintenance | When the SEND DIAGNOSTIC command terminates with the CHECK | 98 |
| ||
| CONDITION status, the initiator must collect the error information using the |
|
| REQUEST SENSE command. The RECEIVE DIAGNOSTIC RESULTS |
|
| command cannot read out the error information detected in the self- |
|
| diagnostics. |
|
| Data loss |
|
| Save data stored on the HDD to other media before requesting repair. Fujitsu | 99 |
| does not assume responsibility if data is corrupted during servicing or repair. |
|
| High temperature |
|
| To prevent injury, never touch the HDD while it is hot. The DE and LSI | 99 |
| become hot during operation and remain hot immediately after turning off the |
|
| power. |
|
| Electrical shock | 100 |
| - To avoid shocks, turn off the power before connecting or disconnecting a |
|
| cable, connector, or plug. |
|
| - Never touch the HDDs while |
|
| Damage |
|
| - Always ground yourself with a wrist strap connected to ground before | 100 |
| handling. ESD (Electrostatics Discharge) may cause the damage to the |
|
| device. |
|
| - To prevent electrical damage to the HDD, turn the power off before |
|
| connecting or disconnecting a cable, connector, or plug. |
|
| - Never remove a PCBA. |
|
| - Never use a conductive cleaner to clean the HDDs. |
|
| - Ribbon cables are marked with a colored line. Connect the ribbon cable |
|
| to a cable connector with the colored wire connected to pin 1. |
|
| - Never open the HDD for any reason. |
|
| Damage |
|
| - Never remove any labels from the HDD or deface them in any way. | 107 |
| - Never open the DE for any reason. Doing so will void any warranties. |
|
|
|
|
4 |
