Fujitsu MBA3073NP manual Mode settings, Default mode settings by Change Definition command, SCSI-3

5.3.3Mode settings

In addition to the previously described settings using setting terminals, the HDD is provided with several mode settings. The mode settings are enabled by specifying the CHANGE DEFINITION command. Table 5.7 lists the mode settings and their settings at factory shipment.

Refer to Subsection 3.1.4 “CHANGE DEFINITION (40)” of the SCSI Logical Interface Specifications for details of the CHANGE DEFINITION command.

Table 5.7 Default mode settings (by CHANGE DEFINITION command)

Mode setting	Contents
SCSI level	SCSI-3
SYNCHRONOUS DATA TRANSFER REQUEST message	Not sent from HDD
sending
UNIT ATTENTION report mode	Reported
Reselection retry count	Not restricted
WIDE DATA TRANSFER REQUEST message sending	Not sent from HDD
Reselection time-out delay	250 ms
Spindle motor start delay time	0 sec (NP)
	12 sec × SCSI ID (NC)

80 C141-E270