Fujitsu MCM3064AP, MCM3130AP manual Media, from media 4-64 Read Capacity data PMI=1, Prom

Index

read cache 4-38

READ CAPACITY command 4-64 READ CAPACITY data (PMI=0) 4-64 READ CAPACITY data (PMI=1, MO

media, FROM media) 4-64 READ CAPACITY data (PMI=1, PROM

media) 4-65

READ command 4-63,

READ DEFECT DATA command 4-66 READ FORMAT CAPACITIES command

4-65

READ FORMAT CAPACITIES data format 4-65

READ LONG command 4-68 read-write error recovery page 4-51

RECEIVE DIAGNOSTIC RESULTS command 4-68

recommended optical disk cartridge 2-8 reliability 1-3, 2-7

removable block access capabilities page 4-56

removing optical disk cartridge 5-4 representative model name 2-1 REQUEST SENSE command 4-69 request sense data 4-69 requirement

environment 2-5 power 2-5

reset recovery 4-32 reset response 4-36

response to Get Status when device is specified 4-10

response to Get Status when end point is specified 4-11

response to Get Status when interface is specified 4-11

response to Prevent/Allow/Eject 4-62 revision label 6-3

revision number 6-3

revision number indication 6-4

S

safety standard 1-4 SEEK command 4-74

SEND DIAGNOSTIC command 4-73 sense key 4-70

separte optical section 1-8 service area 3-12, service life 2-7, 6-2 service system and repair 6-2 Set Address 4-12

Set Configuration 4-13 Set Feature 4-14

Set Interface 4-15

setting optical disk cartridge into setting case

	5-10
setup data format			4-3
setup data format for Clear Feature						4-7
setup data format for Get Configuration								4-8
setup data format for Get Descriptor							4-8
setup data format for Get Interface						4-9
setup data format for Get Status					4-10
setup data format for Set Address						4-12
setup data format for Set Configuration
	4-13
setup data format for Set Feature					4-14
setup data format for Set Interface						4-15
shutter	2-10
shutter open		2-9
specification		2-1
MCL3064UA			2-3
MCM3064UB, MCM3130UB					2-2
specification of disk				2-11
specification of drive				2-2
specification of optical disk cartridge							2-8
specification of optical disk drive						2-1
spindle motor		1-7
standard request			4-3, 4-6
standard request code				4-5
standard USB device request (USB1.1)								4-1
standby mode		4-41
standby timer		4-41
START/STOP/EJECT processing						4-75
START/STOP UNIT command					4-74
storage	3-20
storing cartridge			5-8
String	4-23
String descriptor (LANGID and
	Manufacture) 4-23
String descriptor (Product) 4-24
String descriptor (Serial Number)						4-26
supported request			4-1
surface temperature measurement point								3-2

Suspended 4-3

SYNCHRONIZE CACHE command 4-75 system ground (handling of SG and FG)

3-13

T

temperature at measuring point (reference) 3-3

temperature measurement point 3-1 temperature requirement 3-2 temperature requirement at measurement

point 3-2

temperature rise 3-3 test program 6-2

TEST UNIT READY command 4-75

IN-4 C156-E227-01EN