Fujitsu MCM3064AP, MCM3130AP manual Illustrations, Ultra DMA data in transfer initialization timing

Contents

Illustrations

FIGURES

Figure 1.1	The optical disk drive (with panel)	1-6
Figure 1.2	The optical disk drive (without panel)	1-6
Figure 1.3	Configuration of optical disk drive	1-7
Figure 1.4	Block diagram of the control circuit section	1-9
Figure 2.1	Optical disk cartridge	2-8
Figure 2.2	Algorithms for alternate processing	2-11
Figure 2.3	Example of alternate processing	2-12
Figure 3.1	Surface temperature measurement point	3-2
Figure 3.2	Outer dimensions	3-4
Figure 3.3	Outer dimensions	3-6
Figure 3.4	Installation directions	3-9
Figure 3.5	Center of gravity	3-10
Figure 3.6	Mounting frame structure	3-11
Figure 3.7	Service areas	3-12
Figure 3.8	MCM3130AP current waveform (+5 VDC)	3-13
Figure 3.9	Connector and terminal locations	3-14
Figure 3.10	Cable connection diagram	3-16
Figure 3.11	Jumper wire settings at factory shipment	3-16
Figure 3.12	Master device setting	3-17
Figure 3.13	Slave device setting	3-17
Figure 3.14	Cable selection mode setting	3-18
Figure 3.15	Cable selection example	3-18
Figure 3.16	Packing styles	3-21
Figure 4.1	Power mode	4-21
Figure 4.2	Register/PIO data transfer	4-85
Figure 4.3	Multiword DMA data transfer	4-87
Figure 4.4	Ultra DMA data in transfer (initialization timing)	4-89
Figure 4.5	Ultra DMA data in transfer (continuous transfer timing)	4-89
Figure 4.6	Ultra DMA data in transfer (host stop timing)	4-90
Figure 4.7	Ultra DMA data in transfer (device end timing)	4-90
Figure 4.8	Ultra DMA data in transfer (host end timing)	4-91
Figure 4.9	Ultra DMA data out transfer (initialization timing)	4-92
Figure 4.10	Ultra DMA data out transfer (continuous transfer timing)	4-92
Figure 4.11	Ultra DMA data out transfer (device stop timing)	4-93
Figure 4.12	Ultra DMA data out transfer (host suspend timing)	4-94

xiv C156-E227-01EN