Fujitsu XG2600 Remove rack mounting brackets, Change the direction of fans to adjust airflow

XG2600 Hardware Guide Chapter 2 Installation

2.2.3Change Switch Access Configurations from Rear-Access (Factory Default) to Front-Access and Install

This section describes how to change Rear-Access configuration (Factory Default) to Front-Access.

Note For Front-Access configuration to Rear-Access, make the procedure reversed.

Remove rack mounting brackets

1.Remove rack mounting brackets attached to the sides of the switch.

Rack Mounting Clamps

Change the direction of fans to adjust airflow

Change the direction of fans, depending on which switch access configuration to go with, Rear-Access or Front-Access. Check the direction of fans before installing the switch in the rack.

Airflow is as shown below.

•Rear-Access Configuration (Factory Default)

Exhaust Intake

Airflow Label

•Front-Access Configuration

Airflow Label

Intake Exhaust

36 Installation of the switch