XG2600 Hardware Guide

Chapter 2 Installation

 

 

2.6Set up IP address

Please set the IP address at times when it is required.

Eg. When setting the switch through www browser or installing a firmware from the initial state of the purchase. The following commands show how to set up the IP address (ex. 192.168.1.1)

Command (When connecting through management port)

#configure

#oob ip address 192.168.1.1/24 3

#commit

#exit

Command (When connecting through10GBASE-R (SFP+) port)

#configure

#lan 0 ip address 192.168.1.1/24 3

#lan 0 vlan 1

#commit

#exit

Precautions

The IP address is not set at the initial state of the purchase. Please set the IP address through console.

When logging in by console, you will not be able to log in from the www browser. Please make sure to log off from the console after setting up the IP address.

Please set up different network address when setting “oob ip address” command and “lan ip” address command at the same time.

55

Set up IP address

Page 55
Image 55
Fujitsu XG2600 manual Set up IP address, Command When connecting through10GBASE-R SFP+ port